6
RW SERIES INSTALLATION MANUAL
MountingUnits
Remove the unit from the wooden shipping skids (see Figures 1 and 2). Units will be shipped with heavy duty rubber grommets to reduce
sound that can be transmitted through the floor via the frame (see grommets below). For additional sound attenuation, use heavy duty
spring isolation that can reduce sound levels by 3 dBA (see springs below).
Figure 1: Unit Without Enclosure Figure 2: Unit With Optional Enclosure
UnpackingtheUnit
Remove the stretch warp and protective cardboard from the unit. Where applicable, remove the compressor shipping brackets located at
the base of each compressor. To do so, lift up the bottom of the compressor sound jacket and remove the two bolts that hold the bracket
(see Figure 3a). Discard the brackets. On RWXW540, the hold down shipping bolts should then be removed and discarded (Figure 3b).
Figure 3a: Removing Shipping Brackets
Remove wooden shipping skids
CAUTION:Aminimumof24in.clearance
shouldbeallowedforserviceaccess.
General Installation Information cont.
Compressor Shipping Bracket (one on each
side of both compressors)
Figure 3b: Removing Shipping Bolts
Remove shipping bolts,
brackets and all related
hardware
(RWXW360shown)
GrommetsStandard
HeavyDutyMounting
SpringsOptional
IS-325-01 (RWXW096-360)
IS-750-01 (RWXW540)
Commentaires sur ces manuels